MICROFLAT SINE CENTERS
They are used for holding conical objects between Centers for Inspection of parameters like Taper Angle, Run-out, etc.
| ADMIT BETWEEN CENTER | HEIGHT OF CENTER |
|---|---|
| (MM) | (MM) |
| 200 | 75 |
| 200 | 150 |
| 300 | 75 |
| 300 | 150 |
| 400 | 75 |
| 400 | 150 |
| 500 | 75 |
| 500 | 150 |
They are used for holding conical objects between Centers for Inspection of parameters like Taper Angle, Run-out, etc.
Contact us today for free conslutaion or more information.
Get In TouchNeotech Equipments Pvt. Ltd.
Rahul Gore (Director)
No. 401, Gagan Deep Building- 12
Rajendra Place ,
New Delhi - 110008
Telephone: +91-11-25740364, +91-11-64595949
Phone:+91-9540062568, +91-9891799850, +91 9227766422
© 2019 Neotech. All Rights Reserved
Maintain, Managed & Designed by State Serives