|
Standard Thread: 1/4" N.P.T., except
FB-5 & RB-5: 1/8". W-5 comes with a 1/8" N.P.T.
coupler.
|
D-5
Drip Oilers
The drip feed oiler is the most popular method
of lubrication because it allows the operator to adjust the
rate of oil flow. Adjustments are made by turning the valve
to any point between the open and fully closed position. Needle
point and cam-lock valves are available.
|
|
W-5
Wick Oilers
Wick oilers are used in applications where
precise oiling is required and are adaptable to all classes
of machinery. LubeSite's exclusive wick material (foam) replaces
the old fashioned "pipe cleaner", felt, or woven
cotton wicks. The wick material provides easily controlled
oiling rates.
The wick operates through capillary action,
providing a pre-determined flow of oil based on the grade
of oil used.
|
Each unit is also supplied with both a slow
and a fast rate wick, allowing the user to choose the oil
feed rate or to change feed rates as required.
|
|
Standard Thread: 1/4" N.P.T., except
FB-5 & RB-5: 1/8". W-5 comes with a 1/8" N.P.T.
coupler.
|
FB-5
& RB-5 Chain Oilers
As a chain enters and leaves a sprocket,
there is movement between the pin and brushing surfaces. Wear
at these points creates elongation, decreasing both chain
life and efficiency. By maintaining a film of oil between
the pin and brushing, wear can be greatly reduced. Needle
point and cam-lock valves are available.
|
